Programming The Attiny45 With An Arduino As ISP Programmer
In this post, I’ll show you how to program the Attiny microcontrollers via the Arduino IDE using an Arduino board as an ISP programmer.
Attiny 85 Digispark Board
In this post, I’ll show you how to use and program the Attiny 85 Digispark board with the Arduino IDE. I’ll demonstrate how to add the board to the Arduino IDE and how to install the drivers. Finally, we’ll make an example sketch that simply blinks an LED.
DIY SMD Vacuum Pickup Tool
In this post, I’ll show my DIY SMD vacuum pickup tool. I bought this vacuum pump SMD pickup but it had no way to be turned on/off. There is only a hole on the vacuum “pen” that you can cover with your finger to make or release the vacuum. I decided I would mod it and make it operable with a footswitch. When pressed the vacuum pump is turned on and when you let go the vacuum pump is turned off while the valve is opened at the same time to release the vacuum and instantly drop the SMD part from the nozzle.
DIY Solder Paste Dispenser
In this post, I’ll show my DIY solder paste dispenser. It’s powered by a 12V adapter and can be operated by a footswitch(connected via banana connectors). It uses a small membrane air pump/compressor to dispense the solder paste/flux. Additionally, there is a solenoid air valve connected to the airline so the pressure can be released after you let go of the footswitch which prevents the solder paste or flux from oozing out. The pump and valve timing is controlled through a relay module by an attiny45 microcontroller.
