In this post, I’ll show you how to measure the length or find a break in a coaxial cable with the help of your oscilloscope and waveform generator. We can do this using signal reflection that occurs when a transmission line is not terminated correctly.
In this post, I’ll show you how to measure the value of capacitors and inductors with your oscilloscope and waveform generator. To measure the capacitor we’ll simply which will charge(periodically with a square wave) it through a resistor and measure how much time it takes the capacitor to charge to 63% we can then calculate its value according to the RC time constant formula which is t = RC. We’ll rearrange it to C = t/R to get out the capacitance.
In this post, I’ll show you how to make a cheap portable spectrum analyzer from a TV receiver dongle. The dongle gets sold as a TV (DVB-T) however its an SDR(software defined radio) which means that it can be used to receive pretty much any RF signal(depending on the chip used up to 1-2 GHz) and turn it into a digital one to be later processed by software.
Usually, you would just buy the whole IR module which contains the transmitter, receiver, and amplifier. However, in this post, I’ll show you how you can make your own IR distance sensor/motion detector module.
In this post, I’ll show you a handheld induction heater I made. I bought the ZVS driver circuit board and coil quite some time ago but I just recently saw someone made a very neat 3d printed case for it on thingiverse and decided to make a handheld induction heater out of it. This one is smaller and much less bulky than the other one I made wrote about in this post.
In this post, I’ll show you the induction heater I made. I bought the board and coil as it’s easier and quicker than making them on your own. It’s rated for 2000W but the maximum power I can get out of it is 1200W because that’s as much as the power supply I’m using can supply.
In this post, I’ll show you how to make a signal generator and oscilloscope from a PC soundcard. I used a cheap USB soundcard so in case the input voltage gets too high, I don’t damage my PC. This signal generator and oscilloscope obviously don’t have the best specs and are very limited. They can produce/measure a very narrow range of voltages and frequencies(0-20KHz).
In this post, I’ll show you how to use and program the Attiny 85 Digispark board with the Arduino IDE. I’ll demonstrate how to add the board to the Arduino IDE and how to install the drivers. Finally, we’ll make an example sketch that simply blinks an LED.
In this post, we’ll see how to make an SD card reader shield for the Arduino. It’s pretty simple as it’s just a matter of connecting the proper Arduino pins to the correct pads on the SD card adapter. Additionally, resistors need to be added for certain pins. These will form voltage dividers that will drop down the signal voltage for the SD card from 5V to around 3.3V.
In this post, I’ll show my DIY SMD vacuum pickup tool. I bought this vacuum pump SMD pickup but it had no way to be turned on/off. There is only a hole on the vacuum “pen” that you can cover with your finger to make or release the vacuum. I decided I would mod it and make it operable with a footswitch. When pressed the vacuum pump is turned on and when you let go the vacuum pump is turned off while the valve is opened at the same time to release the vacuum and instantly drop the SMD part from the nozzle.